General FlexBind® Printing Guidelines
Paper orientation while printing
- The hinge should be along either the back or the front of the press while printing to improve toner/ink transfer into the recessed gap. See Illustration.
Feed drawer stacking
- Fan stack gently before loading into the feed drawer.
- If possible, assign a drawer to FlexBind® sheets to prevent excessive handling during repetitive loading and unloading between jobs.
Ream handling
- Do not flex the hinge before printing
- Do not straighten stacks of FlexBind® sheets by resting the stack on the hinge side of the sheet.
Trimming
- Trimming can be done individually with an in-line trimmer or by stacking multiple books and guillotine cutting the stack.
- Be sure to use a sharp knife to cut the film cleanly without tearing.
- Trim 4 sides of the sheet. Be sure to cut the spine of the FlexBind® page to the proper width for the intended binding method
Image position
- Image placement on the FlexBind® sheet should be centered in the hinge gap, or printed over the gap. See illustration.
- If there is difficulty getting toner transfer into the recessed gap, it is recommended to print only to the edge of the gap. (See #1 below)
- Images extending across the binding will need to be individually verified for registration.
- The image should be printed on the laminate as necessary. The laminate is coated to be toner receptive.
